Arbor #4MT Suits 3/4in Shank Cutters Max. DOC 50mm Pipe Cutters #4 Morse Taper spindle

#4 Morse Taper spindle

Not for use on Steel pipe

0kg Approved to CE Standard: EN 1494:2000+A1:2008 WARNING: THIS JACK MUST BE USED ONLY ON HARD LEVEL SURFACES AND BE FREE TO ROLL DURING LIFTING AND LOWERING

Quiet operation

Arbor #4MT Suits 3/4in Shank Cutters Max. DOC 50mm Pipe Cutters #4 Morse Taper spindleThese arbors are designed to adapt conventional machines eg. drill presses lathes milling machines and others to accept Holemaker annular cutters. This becomes a very economical alternative to normal methods of drilling or boring large diameter or deep holes. By adding an extension arbor and long series annular cutter to your industrial arbor you can achieve depths of up to 320mm in hollow section steel. Time savings in excess of 40% over normal